Turn a pressure washer into a high powered foamer!
Cover your vehicle in a flurry of foam quickly with the Foam Cannon HP! This foam lance works with a pressure washer to produce a thick, clinging foam. Give your vehicle a "touch-free" wash with this high powered foam gun. The Foam Cannon HP will blow you away! The kit includes a solid brass male nipple and a common pressure washer fitting.
The benefit of using a foam gun to deliver the soap to the vehicle is that it doesn't require you to touch the vehicle, which could rub dirt against the paint. The Foam Cannon HP sprays the vehicle with a thick coat of soap to loosen and lubricate dirt. On dusty or lightly dirty vehicles, you may not even need to hand-wash. The Foam Cannon HP minimizes the amount of hands-on contact with the vehicle, which can minimize wash-induced swirls. Plus, the Foam Cannon HP is a blast!
You've never seen a foam gun like this! The Foam Cannon HP is capable of such a high volume of foam, a vehicle can be completely whited out. The foam clings to vertical panels and provides the lubrication you need for a safe car wash. The foam provides a pre-soak that loosens dirt and grime so hand-washing is easier.
The Foam Cannon HP works with a pressure washer. The velocity of the water combined with a quality car shampoo will generate amazing suds. This wash process actually uses less water at a higher pressure, so its eco-friendly, too.
The Foam Cannon HP is made of brass for maximum durability with a 1 liter fluid tank for the car shampoo. A vertical jet nozzle is included so you can apply foam or rinse in a sweeping side to side motion. This nozzle allows you to work around and then down the vehicle, which is the recommended way to wash a vehicle.
For the best results, use a foaming shampoo in your Foam Cannon HP. These shampoos are developed specifically for foam guns and produces an incredible amount of foam. It may take some experimentation to get your preferred dilution, but typically start with 1 ounce of shampoo. Pour the shampoo into the Foam Cannon HP tank, hook it up to your pressure washer, and let the foam fly!
The Foam Cannon HP is rated for 5.3 gallons per minute for high powered cleaning. The Foam Cannon HP is excellent for fast-paced cleaning in a detail shop or mobile detailing service. It cuts down on the amount of manual washing needed, and it puts on quite a show!
To maintain your Foam Cannon HP, rinse it out after every use. Six fittings are available for purchase for virtually any pressure washer. A male nipple is included to connect the fitting to the Foam Cannon HP, as well as a commonly used pressure washer fitting (pictured). If the included fitting is not the fitting you need, please see the options below that can be purchased separately.
Not sure which fitting you need? We can help!
The Foam Cannon HP attaches to the trigger/gun assembly for your pressure washer in the exact same way that your wand currently does.You will just need to remove the wand and look at the fitting that you currently have and match it up to one of the fitting that we offer below. The Foam Cannon HP will connect in exactly the same way. Note: If you have a Karcher K3 X Series pressure washer you will need the Karcher HD/HDS fitting in addition to the Karcher X Series fitting (Sold Separately).
Scroll down for complete instructions.
Rated Pressure - 160 bar
16 MPa - 2,300 psi
1,100 - 5,000 PSI
1.8 - 5.3 GPM
140 degree temp
Adjustable Fan Blades (jet-width)
You May Also Like
Fast, friendly service. Highest quality products available anywhere! Completely satisfied I recommend Wolfgang. There was no put on hold to speak to knowledgeable Sales Rep for advice who understood clearly what is in their complete product line and was very helpful. Truly German American Technology at it's finest. Thanks Wolfgang